Country in brackets is the transmitter site and not necessarily the
country of origin, unless specified. If two countries are in brackets,
first one is transmitter site. After that, the date, time and frequency
in kHz is listed. All times in UTC and all stations heard on TECSUN
PL-380 portable in Fort Worth, Texas, USA, with 25 foot reel wire
antenna, on a first floor, unless otherwise noted.
[RWANDA/GERMANY] 02/15/15, 1828, 17800 khz -- Deutsche Welle
from Kigali, Rwanda, in Hausa language. Two males talk on unknown
subject. Decent signal for daytime, considering this is coming from
East Africa. Listened for about five minutes. SINPO 33233.
[USA] 02/15/15, 1842, 15610 khz -- EWTN (Catholic) Radio transmitting
from Vandiver, Alabama. "Vatican Insider" program with female announ-
cer. Strong, clear signal with a little noise, as typical for this frequency.
[CUBA] 02/15/15, 1845, 11635 -- Atencion Cuba spy station with short
set of numbers being read in Spanish by female ("tres, dos, ocho,
siete, siete"), followed by data-like sounds for several seconds, then
more numbers, and so on. SINPO 45454, good signal. It seems like
Cuban spy activity hasn't slowed down since the beginning of thawed
relations with the US.
[USA] 02/15/15, 1858, 15825 -- Religious talk by male, then station ID
and new show at top of hour (Dr. James Blank [sp?]). Male prays while
female translates into Spanish. SINPO 44344.
Tuesday, February 17, 2015
Tuesday, February 3, 2015
A QSL card is what a radio station (or amateur radio operator) will
send a listener as confirmation of a reception report. For example,
if I hear ham radio operator KP4X3 on my receiver, I'll send him or
her a letter or e-mail letting that operator know that I heard their
transmission. Normally, you would specify what date and time you
heard them and on what frequency. It is also common to state what
equipment you were using when you heard the transmission. Sending
this information to the radio operator helps the operator know how
far his or her signal is travelling, how well it can be heard and
whether any tweaks or alterations need to be made to the equipment.
In turn, the radio operator will send a "QSL card", which is often
a postcard, to the listener. This card serves to confirm that what
the listener heard was indeed correct, and that the information
submitted by the listener matches details of the transmission. 'QSL'
is radio code for "do you confirm receipt of my transmission?" or
"I confirm receipt"...[CONTINUE READING]